Table of Contents
Advertisement
Repeat Last
Recut:
Plot
To repeat the last job without re-sending the data.
Copy:
To copy the last job without re-sending the data.
* 1mm gap will be auto-generated between 2 copies).
* If the media length is not enough to continue, it will show
below message on LCM:
* If both functions are enabled at the same time, the cutter will
perform the last setting only.
Mark Positions
2-points:
To manually position 2 points for contour cutting.
3-points:
To manually position 3 points for contour cutting.
To clear up buffer memory.
Set Smoothing
To enable smooth-cutting function.
Cut
Over Cut
To generate an overcut to facilitate weeding.
Set Tangential
To enable the emulated tangential-cutting mode for thicker
Mode
media types and small letter cuts.
Note: while the Offset value setting at 0.000 mm, "Set
Tangential Mode" will automatically be disabled.
Panel Setup
Accept setup command:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via software.
Control panel only:
To accept commands of the Force, Speed, Cutting Quality,
and Offset only via control panel of the cutter.
Restore Default To turn all parameters of the menu items to factory-default
settings.
Save
To save pattern(s) of cutting parameters for later use.
Parameter
Auto Unrolled
To avoid paper jam and motor crash by automatically unroll
Media
media (50cm and up) before cutting while enabled. .
* Auto-unroll only effects on roll/edge media.
* Using Single mode to size media will disable this function
automatically.
* If the length of the rolled media is less than 2 meters or the
weight is light, it is recommended to set this mode disabled.
AAS Offset
To set or modify AAS offset value.
You can refer to "5.3 Printer Test" for more details.
Media Back
To enable to save time on repeated cutting jobs and better
& Forth
tracking.
After cutting job has finished, the media will move back to the
origin, then move to the end of the plot.
The Control Panel
O
u
t
O
f
S
p
a
c e
o
f
C
o
p
i
e
s
f
i
[ DATA CLEAR ]
[ TOOL SELECT ]
;
#
n
i s
h
e d
[ MISC ]
3-5
Puma III User Manual
1~99;
1 per step
1~99;
1 per step
Enable
0.00mm-1.00mm
0.00mm
0.05mm/per step
Disable
Disable
Disable
Advertisement
Table of Contents
