26
23
24
25
FIG 3
1. Loosen the elastic bolt (7) of the large ball head then pull the knob outward.
2. Insert the armrest regulating tube assembly (17) into the inner tube bushing of the main frame
assembly (16). Then, release the elastic bolt (7) of the large ball head and locked into place for desired
height.
3. Attach the computer holder (9) with 2 BOLT (81) under tube assembly (17).
4. Fix the computer (80) onto the computer holder (9) with 4pcs Bolt (73), then connect the cable A1
& A2.
5. The armrest tube assembly (18) is then fixed on the armrest regulating tube assembly (17) with a light
elastic washer (24), a flat gasket (25) and an inner hexagonal cylindrical screw (23). Tighten fully.
6. Finally, the armrest cover (26) is clipped to the armrest tube assembly (18).
IMPORTANT: Make sure the handlebars are tightened fully.
10
| ASSEMBLY INSTRUCTIONS
80
A1
73
18
9
81
17
7
16
A1
Gap
ATTENTION:
Connected with the computer line, to
Gap(A1) corresponding to the Convex
Point (A2) to insert link.
Convex point
A2