Installation and Operation Manual (Rev A)
NOTE: The green link and yellow activity LEDs only light when the SolrenView
DAS is powered.
9.12 Setting up TCP/IP Networking
Connection to the Internet and to the SolrenView web-based monitoring service requires
functioning TCP/IP protocol. This protocol runs over twisted pair Ethernet wiring and requires
certain connections to properly operate. See Section 9.11 or details on establishing Ethernet
connectivity.
By default the SolrenView DAS should automatically configure TCP/IP address from a network
router by using the DHCP protocol. In certain cases it may be necessary to override these
settings or to manually configure the TCP/IP settings.
NOTE: The network router must be 10BASE-T compatible.
NOTE: Customers using SolrenView AIR do not need to setup TCP/IP as this is
done in the factory prior to shipping the inverter.
9.13 Viewing Current TCP/IP settings:
1. Select the Info function on the Main Menu and the press ENTER button.
DOCR- 070254-A
Page 44 of 88
SGI 500XT