Installation and Operation Manual (Rev A)
NOTE: The green link and yellow activity LEDs only light when the SolrenView
gateway is powered.
6.12 Setting up TCP/IP Networking
Connection to the Internet and to the SolrenView web‐based monitoring service requires
functioning TCP/IP protocol. This protocol runs over twisted pair Ethernet wiring and requires
certain connections to properly operate. See Section 6.11 or details on establishing Ethernet
connectivity.
By default the SolrenView gateway should automatically configure TCP/IP address from a
network router by using the DHCP protocol. In certain cases it may be necessary to override
these settings or to manually configure the TCP/IP settings.
NOTE: The network router must be 10T capable.
NOTE: Customers using SolrenView AIR do not need to setup TCP/IP as this is done
in the factory prior to shipping the inverter.
6.13 Viewing Current TCP/IP settings:
1. Select the Info function on the Main Menu and the press ENTER button.
DOCR‐070233
Page 50 of 92
PVI 50‐100KW Series Inverters