Conair GB/ WSB User Manual page 71

Notice that REG shows a full percentage only, no tenths.
only accepts full percentage entries for regrind.
TWELVE software will print up to 3 line groups, 4 components per line,
printing only those that are currently turned on.
The CYCLE heading:
------------
* 11/10/97 * * 16:17:53 *
DATE and TIME this blend cycle was completed.
and Operator numbers have no bearing on blender operation but aid in
identifying this particular blender, and what job was running.
DATA line 1:
------------
FINAL: DISP,%
For each material, each column shows the final dispensed weight of that
material and its percentage of the blend.
In this example Natural dispensed 1908.3 grams.
is not given since it is not set by the operator and is not pertinent.
Color dispense is 77.6 grams, 4.06 percent of the natural dispense,
slightly over the 4 percent requested.
The final number, 2000.1 is the total weight of the blend.
the sum of the component dispenses.
DATA line 2:
------------
RATE: GR/TIME 18224
These numbers show the RATE of dispense for each material.
the numbers that the software used to calculate how long to open the
slide gate or run an auger, in order to dispense the required amount.
This is GRAMS per Interrupts; 1822.4 grams dispensed in 976 interrupts,
which is 4 seconds.
The final number, 9.9 grams, is the TEAR WEIGHT of the weigh bin
displayed just before the cycle began.
DATA line 3:
------------
1ST DISP,TIME
This shows the first dispense in grams for each material and the timing
of that dispense (in interrupts).
------------
RECIPE 0000
------------
0.0 .0 1908.3
------------
976 19993
------------
0.0 00 1908.3
------------
**ID# 051**
RECIPE, ID, Work Order,
------------
77.6 4.06
------------
488 12973 31232
------------
469 77.6 1826
Page 72
The software
Tenths are ignored.
------------ ------
**WO 000000* OPR000
------------ ------
0.0 .00 2000.1
Percentage for natural
It equals
------------ ------
10240 31232
These are
------------ ------
0.0 00
9.9
22