Conair GB/ WSB User Manual page 19

To run a LOWER PERCENTAGE then 00.1 percent, read:
PARAMETERS, _XT parameter.
To place UPPER LIMITS on the thumbwheel settings, read:
PARAMETERS, _SE Parameter.
To LOCK OUT others from changing settings, read:
KEYPAD, STAR FUNCTIONS, (*78) - Changing the Password.
To blend TWO NATURAL materials instead of Natural and Regrind, read:
KEYPAD, STAR FUNCTIONS, (*69) - the TWO NATURALS flag.
To TRACK MATERIAL usage, read:
KEYPAD, VIEW DATA, and PARAMETERS, PRT Parameter.
To VERIFY ACCURACY of the entire system, read:
PRINTER OUTPUT and TROUBLESHOOTING sections.
READ the rest of the manual at your leisure to learn more about how
your WEIGH SCALE BLENDER works and what else it can do.
KEYSTROKE SEQUENCE for these or other SPECIAL FEATURES
With STOP END OF CYCLE switch DOWN,
Turn POWER ON.
Press: *
Press: 22222
To alter a PARAMETER;
Press repeatedly until the parameter you want is displayed.
If you pass it, use the * key to back up.
With the proper one displayed, enter the NEW parameter number.
Enter 5 digits; use leading zeros if necessary.
For correct entries, follow specific directions given in the
PARAMETER section.
Press: EXIT
To make a (*XX) entry:
Be in the PROGRAM mode, same as above.
Press: *
Enter the 2 digit code.
For correct entries, follow specific directions given in the
KEYPAD section, STAR FUNCTIONS.
Press: EXIT
When finished, press EXIT again to exit the PROGRAM MODE.
Wait 5 seconds, until display says (
Display will say (PASSWORD)
Display will say (P
This is the PROGRAM MODE
press: PARA key
when correct parameter has been entered.
Display will say (P
Display will say (INSTR --)
when correct information has been entered.
Page 20
x.x)
x.x)
x.x)