Conair GB/ WSB User Manual page 35

alter the display only.
will operate normally.
*05 Press (*,0,5) to inhibit the (00=CLEAR) display at the end
of the VIEW sequence.
for retrieval of material usage information, may wish to
restrict an operators ability to clear the material usage
data at the controller.
the floor operators ability to clear this data.
toggle between (CLEAROFF) and (CLEAR ON).
*11 Press (*,1,1) to enter the correct date and time into the
real-time clock.
are retrieving information using a printer or are collecting
data by computer.
The first display will indicate USA or EUROPE date format.
USA will cause all dates to be displayed MONTH/DAY/YEAR.
EUROPE will cause all dates to display DAY/MONTH/YEAR.
Use the CE key to toggle from one to the other.
The remaining five entries are two digits each;
MONTH __,
Use the * key to step through all displays without change.
enter new settings where required.
time have been entered at the factory and should never have
to be reset. Of course you may be in a different time zone.
*12 Press (*,1,2) to move the PARAMETER table from ROM to RAM.
This allows system to operate with the parameters that were
originally supplied as default numbers with the system.
EXPLANATION: All PARAMETERS are stored in a table that
resides in three places: ROM, RAM, and EEPROM.
ROM stands for "Read Only Memory." This memory portion of
the circuit board cannot be altered in any way except by
physically replacing this chip on the board.
the program and the copy of the parameter table that we
supply as standard with all controllers.
EEPROM stands for "Electrically Eraseable Programmable Read
Only Memory."
be altered by the computer by special request only, and data
stored here is not lost even if the battery backed up RAM
should lose power.
numbers that are unique to your system.
have set what we believe to be the proper parameters for
your application into the EEPROM.
RAM stands for "Random Access Memory." It is the memory
portion of the circuit board that would go blank if power
were removed from it.
for the RAM so this should never be a problem.
power off and power on, the data and parameters that reside
in RAM are not lost.
most easily corrupted due to unforeseen circumstances in the
In all other respects, the blender
Customers using MLAN or G2 software
This option allows you to remove
Correct date and time is helpful if you
Six entries will be requested.
DAY __, YEAR __,
This memory portion of the circuit board can
It contains all parameters and control
We have provided a battery back-up
However, RAM is the portion of memory
Page 36
HOUR __, MIN __.
The correct date and
It contains
At the factory we
Press * to
On normal