Conair GB/ WSB User Manual page 33

the WEIGH SCALE BLENDER is to dispense materials in the
proper ratios.
same load cells, the accuracy of these ratios is not
affected by zero or full scale errors.
STAR FUNCTIONS available in this mode.
*00 Press (*,0,0) to CLEAR ALL DATA fields.
material usage totals that are viewed with the VIEW key.
you are tracking material usage WITHOUT a computer, you may
wish to reset them to zero on a regular basis for simplicity
of calculations.
track totals, DO NOT clear these totals.
software will most likely loose data if you do.
After VIEWING the data or printing the data using the VIEW,*
key sequence, a display of (00=CLEAR) will appear for 5
seconds.
fields to zero by pressing 00.
exit this sequence without clearing data.
*99 Press (*,9,9) to set flag to enable Weight Calibration of
the Load Cells.
weight calibration keys, ZERO and FULL WT, will function.
Use the * key to toggle flag ON or OFF.
Power On will always set this flag to OFF.
Press EXIT when desired flag status is displayed.
In this mode, you may perform ALL of the functions available in MANUAL
mode, plus additional functions that alters the logic with which the
controller operates.
The PARA (PARAMETER) key operates in this mode.
The SET key has additional functions.
STAR FUNCTIONS are available by pressing the * key and two numbers.
Just as with the MANUAL mode, you can enter this mode only when the
controller is between cycles.
control switch must be in the "STOP - END OF CYCLE" position.
this mode, no automatic dispensing will occur.
TO ENTER THIS MODE: press "*", then enter the correct password number.
The correct password supplied with the unit is "22222". To change this
to another 5 digit number of your choice, see (*78).
PROGRAM mode, the letter "P" shows at the left end of the display.
The following PROGRAM functions are available in the PROGRAM mode.
SETTING: Press the SET key once followed by one of 3 keys: REG, COL,
(SET) or ADD.
If the keypad, or a computer, was used to enter this setting
then it may not match the thumbwheel setting.
Because all components are weighed by the
If you are using a computer to gather and
During this 5 seconds you may reset all data
This flag must be ON before the load cell
KEYPAD - PROGRAM MODE
The sensor must be covered or the sensor
The current thumbwheel setting will be displayed.
Page 34
These are the
The computer
Pressing any other key will
When in the
If
When in