Conair GB/ WSB User Manual page 29

NOTE:
be in over the target by as much as one cycle weight.
The EXIT key will exit the BTCH sequence at any point but
will NOT cause the system to start a new batch.
If an additional 120 volt output is desired for an alarm,
substitute a 4 or 7 for the 00001.
outlet, 7 turns on component 7 output.
If you have a printer connected, totals will print
automatically. (see VIEW, * for details).
FAST: This key will allow you to exceed the normal blending rate
of your unit.
rates of each material, the timing of each component
dispense is very consistent cycle to cycle.
allows one or more FAST REPEAT cycles to follow a normal
calibrated cycle.
dispensed simultaneously, without any weights being taken.
Errors in dispense amounts will not be detected.
in fact, volumetric dispenses, not gravimetric.
dispenses take much less time.
this manner.
This key is NOT FUNCTIONAL unless the 4th digit of the "FLG"
parameter is set to 1 (xxx1x).
MAINTENANCE section, PARAMETER TABLE, "FLG".
The shorter mixing time may be a problem.
FAST REPEAT cycles is kept as low as possible.
repeats may occur.
After pressing the FAST key, use the * key to toggle the
FAST flag ON of OFF.
not operate.
dispense will be followed by up to 4 FAST repeat dispenses.
Press * to toggle between (FAST
Press EXIT, to exit.
When the FAST mode is in operation, the display (
will flash intermittently.
TAG: This key (third row, third key) allows three pieces of
information to be "tagged" onto all data that is either
printed or retrieved through the computer port.
are WORK ORDER, OPERATOR, and RECIPE number.
This key is NOT FUNCTIONAL unless the 2nd digit of the "FLG"
parameter is set to 1 (x1xxx).
MAINTENANCE section, PARAMETER TABLE, "FLG".
Press once to display the current Work Order number
(WO-----). Press again to display the current Operator
number (OPRTR---).
You may enter or change the Work Order or Operator number
when each is displayed.
Fractional cycles are not blended.
Once your system has learned proper flow
In a FAST REPEAT cycle all components are
When set to (FAST OFF) FAST mode will
When set (FAST
Press again for the Recipe (RECP ---).
Page 30
4 turns on the Additive
Throughput may be doubled in
To do this, see the SOFTWARE
ON) every normal calibrated
ON) and (FAST OFF).
To do this, see the SOFTWARE
Recipe number can not be altered.
Total weight may
The FAST key
These are,
These
So the number of
Up to 4
FAST)
The items