Removing The 3.5-Inch Fixed Hard Disk Drives - NEC EXP339 User Manual

Chapter 2 Preparations
Update the system configuration information by following procedure.
1) Connect the AC cord to the server, then push the power switch to power on.
2) If POST screen is indicated, press F2 key of the keyboard and enter BIOS setup screen.
3) The POWER switch is pressed and the power supply of the server is turned off.
4) Remove the AC cord from the server, and leave the AC power of the server off around 30 seconds.
5) Connect the AC cord to the server again, and push POWER switch in order to power on the server.

Removing the 3.5-inch fixed hard disk drives

Remove the 3.5-inch fixed hard disk drives from the HDD cage by using the following procedure.
See steps 1 to 3 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
To remove the side cover and front bezel, see Chapter 2 (1.3 Removing the Side Cover and 1.4
Removing the Front Bezel).
Disconnect the power cable and interface cable from the hard disk drives.
Press the part shown in the figure to unlock the HDD tray, and then remove the hard disk drive out
from the HDD cage.
Important
When disposing of the hard disk drives, follow the instructions described in
Chapter 1 (15 Transfer, movement, and disposal) in Safety Precautions and
Regulatory Notices.
Express5800/T110j User's Guide
1. Installing Internal Optional Devices
63