Table of Contents
Advertisement
Chapter 2 Preparations
Position of the connector
Connect the cable to the connector shown in the figure below.
2.
Install the RAID controller into the PCI slot #4 and fix it in place. Be careful not to disconnect the
cable.
3.
Connect the cables and components that you removed.
Removal
To remove the flash backup unit, reverse the installation procedure.
48
Tips
For the position of the connector of N8103-206/207/208, refer to the manual
attached to N8103-206/207/208.
flash backup unit control cable
RAID Controller
Express5800/T110j User's Guide
1. Installing Internal Optional Devices
RAID Controller
Advertisement
Table of Contents
