Removing The 3.5-Inch Hard Disk Drives - NEC EXP339 User Manual

Chapter 2 Preparations
Update the system configuration information by following procedure.
1) Connect the AC cord to the server, then push the power switch to power on.
2) If POST screen is indicated, press F2 key of the keyboard and enter BIOS setup screen.
3) The POWER switch is pressed and the power supply of the server is turned off.
4) Remove the AC cord from the server, and leave the AC power of the server off around 30 seconds.
5) Connect the AC cord to the server again, and push POWER switch in order to power on the server.

Removing the 3.5-inch hard disk drives

Remove the 3.5-inch hard disk drives from the HDD cage by using the following procedure.
To remove the front bezel, see Chapter 2 (1.4 Removing the Front Bezel).
Release the lock lever and open the handle.
68
Important
When disposing of the hard disk drives, follow the instructions described in
Chapter 1 (1.5 Transfer, movement, and disposal) in Safety Precautions and
Regulatory Notices.
Note
If you remove a disk due to a hard disk drive failure, check the slot with its DISK
LED lit in amber.
Express5800/T110j User's Guide
1. Installing Internal Optional Devices
DISK LED