Installing The Analog Devices Sdp Drivers - Analog Devices ADP5350-EVALZ User Manual

UG-1104

INSTALLING THE ANALOG DEVICES SDP DRIVERS

To install the Analog Devices system demonstration platform
(SDP) drivers, complete the following steps:
1. After installing ADP5350-EVALZ
installation of the SDP drivers begins.
2. Click Next to install the drivers (see Figure 7).
Figure 7. SDP Drivers Setup Wizard
3. Click Install after verifying the destination folder. Ensure
that the system environment has enough space (see Figure 8).
Figure 8. Verify the Destination Folder
GUI software, the
Rev. A | Page 4 of 17
ADP5350-EVALZ User Guide
4. Click Finish to complete the driver installation (see Figure 9).
Figure 9. Driver Installation Complete
5. To verify that the USB driver is installed properly, click
Start. Then select Control Panel > System and open the
Device Manager (see Figure 10).
Figure 10. Verify Driver Installation
When the USB dongle is connected to a PC port different from
the one used to install the driver, the PC device driver may
require that the driver be installed again for that specific port. If
this occurs, repeat Step 1 through Step 4.