Software Driver Installation - National Instruments PXI-8101 User Manual

Software Driver Installation

© National Instruments Corporation
What if I don't have a Y-splitter cable? Can I still use a mouse and
keyboard?
If you do not have a Y-splitter cable, plug a USB keyboard into any
USB connector. You can also plug a USB mouse into any USB connector.
How do I connect a standard 25-pin LPT cable to the
NI PXI-8101/8102?
The NI PXI-8101/8102 uses a type C LPT connector. Most parallel port
devices use a type A connector. To use a device with a standard type A
LPT connector, you need to use a type C-to-type-A LPT adapter. Parallel
port adapter cables, part number 777169-01, are available through the
online catalog at
ni.com/products
How do I connect a VGA monitor to the NI PXI-8101/8102?
A VGA-to-DVI-I adapter (part number 762559-01) is included with your
kit. You can use this adapter to connect a VGA monitor to the DVI-I port.
How do I connect two monitors to the NI PXI-8101/8102?
To use both DVI and VGA, you can purchase a DVI to DVI and VGA
splitter cable through National Instruments (part number 780868-01).
Refer to KnowledgeBase 497ERQ7N, Dual Monitors with the DVI
Connection on PXI controller, at
How do I install or reinstall the video driver?
Refer to KnowledgeBase 3H3COSD8, What Peripheral Drivers Should I
Use with My PXI or VXI Controller?, at
How do I install or reinstall the Ethernet driver?
Refer to KnowledgeBase 3H3COSD8, What Peripheral Drivers Should I
Use with My PXI or VXI Controller?, at
Chapter 4
.
ni.com/support
ni.com/support
ni.com/support
4-3
Common Configuration Questions
for more information.
.
.
NI PXI-8101/8102 User Manual