System Cmos - National Instruments PXI-8101 User Manual

System CMOS

1 Push-Button Switch SW2
© National Instruments Corporation
The NI PXI-8101/8102 contains a backed-up memory used to store BIOS
configuration information.
Complete the following steps to clear the CMOS contents:
1. Power off the chassis.
2. Remove the controller from the chassis.
3. Press and hold down push-button switch SW2 for 2 to 3 seconds.
The switch location is shown in Figure 2-3.
4. Reinstall the controller in the chassis.
Figure 2-3. Clearing the CMOS Contents
Chapter 2
1
2-15
Installation and Configuration
NI PXI-8101/8102 User Manual