Table of Contents
Advertisement
Installation and Configuration
Installing the NI PXI-8101/8102
To protect both yourself and the chassis from electrical hazards, leave the chassis
Caution
powered off until you finish installing the NI PXI-8101/8102 module.
© National Instruments Corporation
This chapter contains information about installing and configuring your
NI PXI-8101/8102 controller.
This section contains general installation instructions for the
NI PXI-8101/8102. Consult your PXI chassis user manual for specific
instructions and warnings.
1.
Plug in your chassis before installing the NI PXI-8101/8102. The
power cord grounds the chassis and protects it from electrical damage
while you install the module. (Make sure the power switch is
turned off.)
2.
Remove any filler panels blocking access to the system controller slot
(slot 1) in the chassis.
3.
Touch the metal part of the case to discharge any static electricity that
might be on your clothes or body.
2-1
2
NI PXI-8101/8102 User Manual
Advertisement
Table of Contents
