Table of Contents
Advertisement
© National Instruments Corporation
•
Device Reset Delay—This setting specifies the number of seconds the
Power-On Self Test will wait for a USB mass storage device to start.
The default is 20 seconds.
In addition, the following option is available for each detected device if a
USB mass storage device is present:
•
Emulation Type—This setting specifies how the BIOS will present
the USB mass storage device to the system. This option can be used to
present a USB mass storage device as a floppy, Zip, hard disk, or
CD/DVD ROM drive. The default is Auto, which allows the BIOS to
treat small USB Flash disk drives as floppy drives and larger USB
Flash disk drives as hard disk drives.
Serial/Parallel Port Configuration Submenu
Use this submenu to apply alternate configurations to the serial and
parallel ports. Normally, you do not need to modify these settings, as
the factory default settings provide the most compatible and optimal
configuration possible.
•
Serial Port 0 Configuration—Use this setting to access the Serial
Port 0 Configuration submenu. Refer to the Serial Port 0
Configuration Submenu section for more information.
•
Parallel Port Configuration—Use this setting to access the Parallel
Port Configuration submenu. Refer to the Parallel Port
Configuration Submenu section for more information.
Serial Port 0 Configuration Submenu
•
Serial Port—This setting enables or disables the onboard serial port.
The default value is Enabled.
•
Device Settings—This item displays the current base address and
interrupt request level (IRQ) information for the onboard serial port.
•
Change Settings—This setting changes the base address and interrupt
request level (IRQ) information for the onboard serial port. The default
value is Auto.
Parallel Port Configuration Submenu
•
Parallel Port—This setting enables or disables the onboard parallel
port. The default value is Enabled.
•
Device Settings—This item displays the current base address and
interrupt request level (IRQ) information for the onboard parallel port.
Chapter 2
2-9
Installation and Configuration
NI PXI-8101/8102 User Manual
Advertisement
Table of Contents
