Other Connectors Configuration; 2-9.1 On-Board Fan Connectors - SOLTEK 85DRV5-L Installation Instructions Manual

85DRV5 / 85DRV5-L

2-9 Other Connectors Configuration

This section lists out all connectors configurations for users' reference.

2-9.1 On-board FAN Connectors

PS/2 Mouse
(on top)
PS/2 K/B
(underside)
RJ 45
(on top)
USB0 (middle)
USB1 (underside)
Main Power
Connector
Peripheral Power
Connector
VIA VT6103
PHY (LAN Controller)
1
CD1
AC'97
Codec
Audio Codec
AUDIO1
14
WOL1 JUSB2
1 1
Both Sensor and No-sensor Fan Connectors support CPU/AGP/Sys-
tem/Case cooling fan with +12V mode. When connecting the wire to
any Fan Connector, user should make sure that the red wire is for the
positive current and should be connected to pin +12V, and the black
wire is Ground and should be connected to pin GND. A Hardware Moni-
tor chipset is on board, with which user can install a Hardware Monitor
Utility and read the fan speed transmitted from the sensor fan. Otherwise,
user can read the fan speed from the "Hardware Monitor Status" in
CMOS BIOS.
A running fan will send out 2 electric pulses per rotation of its fan
blade. A Sensor Fan Connector will count the electric pulses and send
the information to the System Hardware Monitor which in turn will work
out the fan rotation speed and display it with the monitoring program.
RT1
VIA
P4x266E
AGP 4X/2X
PCI 1
PCI 2
VIA
PCI 3
VT8235
1
JP1
PCI 4
1
JBAT1
RT2
PCI 5
1
FAN3
IT8705F
LPC I/O
PCI 6
SCR1
FLASH BIOS
10 14
10
JUSB1
1
1
1
GND
+12V
SENSOR
Sensor Conn.
FAN2, Sensor Fan Connector
(Yellow)
FAN4, No-sensor Fan Connector
FAN1, Sensor Fan Connector
(Yellow)
FAN3, No-sensor Fan Connector
30
Void
+12V
GND
No Sensor