Call Settings - Gigaset N610 IP PRO Instruction Manual

Telephony settings

Call settings

On this page you can make advanced settings for VoIP connections.
It is only available for the user role admin.
Settings Telephony
Call transfer
Participants can transfer a call to another participant as long as the PBX/provider supports this
function. The call is transferred using the handset menu (via the display key) or using the R key.
You can expand or change the settings for call transfer.
Call transfer via R key
Activated: Users can connect two external callers with each other by pressing the R key. The
connections with both parties are terminated.
Transfer call by on-hook
Activated: The two participants are connected with one another when the user presses the end
call key. The intermediary's connections with the participants are terminated.
Determine target address
Select how the transfer target address (Refer-To URI) is to be derived:
From transfer target's AOR (Address of Record)
From transfer target's transport address (Contact URI)
Most common PBX platforms show good results by using the AOR as transfer target address.
In case there are problems with transfer especially via transparent proxies, rather than call
switching PBX, it might be worthwhile to test with transfer target address derived from transfer
target's transport address.
Access Code
You may have to enter an access code for external calls (external prefixes e.g., "0"). You can save
this access code in configuration. These settings apply to all registered handsets.
Enter an access code in the Access Code text field. Value: max. 3 digits (0 – 9, *, R, #, P)
Select when the phone numbers should be automatically prefixed with the digits, e.g. when
dialling from a call list or a directory.
46
Call settings