Download Print this page

Advertisement

Quick Links

FAQ Nx70 - Installation
Valid for:
N670
N870 N870E
Introduction
The N870(E) and N670 have only one hardware, the role determines its functionality.
When you connect a N870(E) to the Power, it will
change the role of the device using the procedure described on this page.
Preparation
1.
Perform DECT measurement and site planning
During the planning phase of your DECT network you should have created an installation plan for the DECT managers and base stations.
2.
Connect the devices to the local network.
3.
Register at least one device as Integrator/DECT manager.
4.
Mount the devices at the planned locations.
5.
Configure the local network settings via web configurator.
You need a PC connected to the local network, so that you can configure your telephone system via web configurator.
6.
Perform a firmware update.
7.
Register the base stations to the telephone system.
8.
Configure the base station synchronization.
9.
Configure VoIP PABX or provider.
10.
Register handsets and perform handset configuration.
11.
Create a backup to save your configuration
start by default as a "base station"
. A N670 will
start by default as an "All-in-One".
You can

Advertisement

loading
Need help?

Need help?

Do you have a question about the N870E and is the answer not in the manual?

Questions and answers

Summary of Contents for Gigaset N870E

  • Page 1 FAQ Nx70 - Installation Valid for: N670 N870 N870E Introduction The N870(E) and N670 have only one hardware, the role determines its functionality. When you connect a N870(E) to the Power, it will start by default as a "base station"...
  • Page 2 How to change the role. Per default, the device is delivered as a base station. To change the role to a Integrator/DECT Manager or to reset the base, please follow this instruction. Let the device fully start up (New N870 has role "base station", new N670 has role "All-in-one").
  • Page 3 Programming mode Progr. Role Description activate by option Programming mode press & hold key for around 10 seconds. (LED's turn off) The device will show direct the role Base station when entering the programming mode. DHCP Set role to Base (default). Green press &...

This manual is also suitable for:

N670N870N 70 series