Gigaset N610 IP PRO Instruction Manual page 10

First steps
Connecting the power supply
Your N610 IP PRO is supplied with sufficient power via PoE (Power over Ethernet) if
the device is connected to an Ethernet switch with PoE functionality (PoE class
IEEE802.3af). In this case, you do not need to connect the device to the mains power
supply.
1
Pull down the lower part of the housing and fold it forwards
Connect the power supply cable to the power connector on the base station
Plug in the power supply
Connecting to the LAN
You can connect the N610 IP PRO to your local network via a router or switch. A VoIP PBX is
required for Internet telephony. This must be accessible via the local network and must have
network access.
You also need a PC connected to the local network, so that you can configure your telephone
system via the web configurator.
For each device to be connected to the local network an Ethernet cable is required.
Insert a plug from an Ethernet cable into the LAN connection socket at the bottom of the
device .
1
Insert the second Ethernet cable plug into a LAN socket for your local network or on the PoE
switch .
2
Close the flap.
10
3
.
3
1
2
.
1
.
2
2