Mqa Decoding "Mqa Decoding; Enabling The Native Playback For Dsd Signal "Dsd Native; Disabling Audio Output "Digital Output"/"Analog Output; Setting The Sampling Frequency "D.output Fs - Technics SL-G700M Operating Instructions Manual

MQA decoding
"MQA Decoding"
An MQA file or stream needs to be decoded to
deliver the master quality audio. Switch the MQA
decoding function to "On" or "Off". (⇒ 100)
• The factory default is "On".
Enabling the native playback for
DSD signal
"DSD Native"
Enabling the native playback for DSD signal from
the USB device or network device (DMP/DMR).
• The factory default is "Off".
• DSD signal which is input to this unit from USB
device or network device (DMP/DMR) is converted
to linear PCM signal (up to 192 kHz).
• The setting can be changed while playing back the
USB device or network device but playback may
stop.
• Set to "Off" when the content is not played back
properly.
Disabling audio output
"Digital Output"/"Analog Output"
Disabling the audio output of unused terminals
minimises noise and allows playback in higher audio
quality.
• The factory default is "On".
• Set "Digital Output" to "Off" to disable the digital
audio output.
• Set "Analog Output" to "Off" to disable the
analogue audio output.
Setting the sampling frequency
"D.Output fs"
You can set an upper limit on the output sampling
frequency range. Please note that the range that
can be processed differs depending on the amplifier
with digital input terminal. For details, refer to the
operating instructions of the connected device.
• The factory default is "32kHz-192kHz".
• Set "Digital Output" to "On" to use this function.
• 96 kHz or 192 kHz can be set as the upper limit on
the output sampling frequency range.
91
(Continued)