Using The Remote Control; Remote Control Mode - Technics SL-G700M Operating Instructions Manual

Using the remote control

2
R03/LR03, AAA
(Alkaline or manganese batteries)
Note
• Insert the battery so the terminals (
match those in the remote control.
• Point it at the remote control signal sensor on this
unit. (⇒ 18)
• Keep the batteries out of reach of children to
prevent swallowing.

Remote control mode

When other equipment responds to the supplied
remote control, change the remote control mode.
• The factory default is "Mode 1".
1 Press [NWP].
2 Press [SETUP].
3 Press [ ], [ ] to select "Remote
Control" and then press [OK].
• The current remote control mode of this unit is
displayed.
4 When "Set Mode 1/2" is displayed,
change the remote control mode of the
remote control.
To set "Mode 1":
Press and hold [OK] and [1] for at least
4 seconds.
To set "Mode 2":
Press and hold [OK] and [2] for at least
4 seconds.
5 Point the remote control at this unit,
and press and hold [OK] for at least
4 seconds.
• When the remote control mode is changed, the
new mode will appear on the display for a few
seconds.
1
24
and )
(Continued)