Technics SL-G700M Operating Instructions Manual page 120

Not Valid
The function you have tried to use is not available
with the current settings.
• Check the steps and settings.
• Registration/subscription may be required for
some functions.
• Another input source than "CD" cannot be
selected while this unit is in "Pure Disc Playback"
mode. (⇒ 46)
• "Filter" cannot be changed in the following
conditions. (⇒ 93)
 While playing back Super Audio CD
 "MQA Decoding" is set to "On".
 "Coherent Processing" is set to "On".
 While playing back DSD signal and "DSD Native"
is set to "On".
Operate via App
Remote control is not available.
• Use the connected device or application for
operating.
PGM Full
The number of programmed tracks is more than 20.
• No more track cannot be programmed.
Please Wait
This is displayed, for example, when this unit is
turned to standby/on. (For up to approx. 1 minute
and 30 seconds)
• Wait for the display disappears.
Reading
The unit is checking the CD information.
• After this display has disappeared, start operating.
"Remote
The remote control and this unit are using different
modes.
• Change the mode on the remote control. (⇒ 24)
Searching
The unit is checking the media server on the
network.
• Check to see if there is a server in same network.
Unlocked
"COAX", "OPT" or "USB-B" is selected, but no
device is connected or no audio is played back.
The sampling frequency components, etc. of the
audio signals are not input correctly.
• Check the connection with the device. (⇒ 51)
• For supported formats, refer to "Format".
(⇒ 131)
USB Over Current
USB device connected to the front/rear of this unit
is drawing too much power.
• Disconnect the USB device and turn the unit to
standby and on again. (⇒ 47)
• Turn this unit off and on.
• Check if there is no problem on the USB device.
(⇒ 123)
" (" " stands for a number.)
120
(Continued)