Defining Ext3-Xr-Tr And Ext3-Tr - Kramer EXT3-TR User Manual

Defining EXT3-XR-TR and EXT3-TR

This section defines
The extender device functions as a transmitter or receiver as defined by the SETUP
DIP-switch 1 setting on the rear panel (see
# Feature
SETUP 2-way
1
DIP-switch
HOST USB B 2.0
2
Connector
ACTIVE HOST
3
LED
ACTIVE Rx LED
4
IN LED
5
OUT LED
6
TX LOOP
7
LINK LED
8
ON LED
9
EXT3-XR-TR, EXT3-TR – Defining EXT3-XR-TR and EXT3-TR
EXT3-XR-TR and EXT3-TR.
Figure 1: EXT3-XR-TR 4K60 HDMI/USB Extender Front Panel
Figure 2: EXT3-TR 4K60 HDMI/USB Extender Front Panel
Function
Set the HDBT Range Mode.
DIP 1 DIP 2
Off (up) Off (up)
Off (up) On (down)
On (down) Off (up)
On (down) On (down)
Connect to the USB host (for example, a laptop) to communicate with the USB
peripheral devices (for example, a smart board) connected to USB device ports
on either the transmitter or the receiver sides of the extender (see
the 4K60 HDMI/USB Extender
Lights orange when the USB host side is active
Lights green when the extender receiver function is active
Lights blue when an active HDMI input signal is detected on HDMI IN.
Lights blue when an output acceptor device is connected.
Transmitter mode Lights blue an active signal is transmitted on the Tx LOOP
port.
Receiver mode N/A
Lights green when the HDBT active link connection is established.
Lights green when the device receives power.
Setting the DIP-Switches
State Description
Standard range mode (default).
Ultra-long range mode.
For future use.
For future use.
on page 7).
Kramer Electronics Ltd.
on page 10).
Connecting
4