Connecting Ext3-Xr-Tr And Ext3-Tr - Kramer EXT3-TR User Manual

Connecting EXT3-XR-TR and EXT3-TR

This section describes the connection procedure for
procedure is described for
connections.
To connect EXT3-XR-TR as illustrated in the example in
1. Use the DIP-switches
receiver (see
2. Connect the HDBT port
the EXT3-XR-TR
3. On the EXT3-XR-TR
the HDMI Tx IN connector
4. On the EXT3-XR-TR
to an HDMI acceptor.
12
5. On the EXT3-XR-TR
to an HDMI acceptor (for example, a smart TV).
6. Connect the USB ports:
▪
Connect the HOST USB port to a laptop or room PC.
The HOST USB port can be connected to either the transmitter or the receiver
side, as necessary & set Active host DIP-switch 2 accordingly.
▪
Connect the USB DEVICE ports on the transmitter side to USB devices (for example,
the room microphone, mouse, and keyboard).
▪
Connect the USB DEVICE ports on the receiver side to USB devices (for example, a
camera to USB 1, a soundbar to USB 2 and a smart board to USB 3).
note that some USB devices, for example, the camera, require the USB 1
disconnection function.
USB devices can be connected to both the transmitter and receiver sides, as
necessary.
EXT3-XR-TR, EXT3-TR – Connecting the 4K60 HDMI/USB Extender
EXT3-XR-TR
Figure 5: Connecting to EXT3-XR-TR
to define one device as a transmitter and the other as a
18
Setting the DIP-Switches
on the EXT3-XR-TR
10
receiver side.
transmitter side, connect an HDMI source (for example, a laptop) to
.
11
transmitter side, connect the HDMI Rx OUT/Tx LOOP connector
receiver side, connect the HDMI Rx OUT/Tx LOOP connector
EXT3-XR-TR
and is the same for EXT3-TR
Figure
on page 10).
transmitter side to the HDBT port
Kramer Electronics Ltd.
and EXT3-TR. This
except for the IG LAN
5:
on
10
12
8