Agilent Technologies E7474A Getting Started Manual page 96

CAUTION
Setting Up Your System
Universal Serial Bus (USB), 4-port Adapter Configuration
To Connect the USB Serial Converter for Use with a Laptop or a
Non-Agilent Provided Pen Tablet
This procedure is for customers wishing to use the device on laptop systems in
a drive test environment, or, indoor customers installing on their own
computing device.
1. Plug in the EdgePort/4 to the USB port. The device is recognized by
Windows as new hardware.
2. Insert the Windows 98 Inside Out Networks Acceleport 4 driver diskette
in the device's floppy drive.
(For the Fujitsu pen tablet computer, the floppy drive is connected via a
connector exposed by removing the battery. This must be done with
external power connected.)
3. Follow the directions in the New Hardware wizard to select the floppy
drive as the source for the drivers.
4. The drivers load and are configured automatically. The converter is now
ready to use.
To Connect the USB Serial Converter for Backpack Usage
1. Unzip the left shoulder strap pocket.
2. Feed the USB connector through the strap, out through the top, then down
through the hole in the top of the backpack.
3. Pull the cable in and plug it into the USB serial converter.
4. Fasten the USB hub into the case.
The USB connector attaches to the pen tablet on the outside of the case. As
you collect data, watch that you don't bump the USB connector against your
surroundings. Also, be aware of backpack dimensions and weight. Dropping
or bumping the system may cause the measurement system to fail.
106 Agilent Wireless Solutions