Agilent Technologies E7474A Getting Started Manual page 85

Setting Up Your System
Configuring Multiple Receivers and Phones
NOTE
You should not connect GPS antennas to other, non-master receivers, which
may have internal GPS. Only connect a GPS antenna to the master receiver or
GPS system.
2. Connect the hardware security key to the parallel port of the PC.
3. Connect the serial port of the PC to the RS-232 port of the
4. Connect the RF antenna to the RF input of each of the Agilent E645x
5. When applicable, connect the GPS system and antenna as instructed
6. Turn on the GPS system and the PC, and run the application.
7. Select or create the project you are going to use.
Agilent Wireless Solutions
which you connect the computer and the GPS (or one that has internal
GPS).
a. Attach one end of a short cable to the RX LOOP IN connector on the
master receiver. Attach the other end of the short cable to the RX
LOOP OUT of the second receiver. The receivers are designed to
stack one on top of the other.
b. Continue to attach receivers (up to a total of four receivers) as in
step a.
c. When all receivers are connected with short cables, connect one end
of a long cable to the RX LOOP OUT connector on the master
receiver to the RX LOOP IN on the last receiver in the series.
master receiver with an RS-232 cable. The default serial port used by the
application is multiplexed serial, COM1. If your PC uses a different com
port, you can specify a different serial port number in the software when
you configure the project.
receivers. Use the supplied Type-N to TNC adapter, if necessary.
earlier in this guide. See
page 25 for the page to which to refer for your specific GPS and receiver.
Table 2-1, "GPS System Configurations," on
95