Agilent Technologies E7474A Getting Started Manual page 31

Setting Up Your System
Receiver-Based System Setup
Configuring a Trimble Placer GPS 400 or SVeeSix
1. Connect the hardware security key to the parallel port of the PC.
2. Connect the serial port of the PC to the RS-232 port of the
Agilent E645x receiver using an RS-232 cable. The default serial port
used by the application is multiplexed serial, COM1. If your PC uses a
different com port, you can specify a different serial port number.
3. Connect the RF antenna to the RF input of the Agilent E645x receiver.
Use the supplied Type-N to TNC adapter, if necessary.
4. Connect one end of a standard, straight-through, RS-232 9-pin cable to
the GPS RS-232 port of the Agilent E645x receiver. Connect the other
end of the RS-232 cable to the Trimble Placer GPS 400 or SVeeSix
connector.
5. Connect the GPS antenna to the GPS ANT port of the Trimble Placer
GPS 400 or SVeeSix unit.
6. Connect power to the Trimble Placer GPS 400 or SVeeSix and the PC.
7. Turn on the Trimble Placer GPS 400 or SVeeSix, and the PC, and run the
application.
8. Select or create the project you are going to use.
9. Select Configuration mode.
a. Select the Hardware tab.
b. Double-click the GPS icon, or select GPS then click
c. In the Hardware Type box, select GPS (Placer DR, 400, SV6; TAIP)
if the Trimble Placer SVeeSix has TAIP.
See part number XXXXX-63.
d. In the Hardware Type box, select GPS (SV6, SK8; TSIP) if the
Trimble Placer SVeeSix has TSIP (Trimble Standard Interface
Protocol). See part number XXXXX-61.
e. In the Hardware Type box, select GPS (NMEA) if the Trimble Placer
SVeeSix has NMEA. See part number XXXXX-62.
f. Click .
OK
Agilent Wireless Solutions
.
Modify
33