Agilent Technologies E7474A Getting Started Manual page 50

Setting Up Your System
Receiver and Phone-Based System Setup
Configuring a Trimble Placer GPS 400 or SVeeSix
1. Connect the hardware security key to the parallel port of the PC.
2. Connect the serial port of the PC to the RS-232 port of the
Agilent E645x receiver using the RS-232 cable included with the system.
The default serial port used by the application is multiplexed serial,
COM1. If your PC uses a different COM port, you can specify a different
serial port number.
3. Connect the RF antenna to the RF input of the Agilent E645x receiver.
Use the supplied Type-N to TNC adapter, if necessary.
4. Connect one end of a standard, straight-through, RS-232 9-pin cable to
the GPS RS-232 port of the Agilent E645x receiver. Connect the other
end of the RS-232 cable to the Trimble Placer GPS 400 or SVeeSix
connector.
5. Connect the GPS antenna to the GPS ANT port of the Trimble Placer
SVeeSix/Placer GPS 400 unit.
6. Connect the phone cable to a second COM port (different than used in
step 1). On most laptop PCs this will require the use of a Socket Serial I/O
RS-232 card that is installed into the PCMCIA slot on your PC.
7. Connect power to the Trimble Placer GPS 400 or SVeeSix and the PC.
8. Turn on the Trimble Placer GPS 400 or SVeeSix, the PC, and the phone
and run the application.
9. Select or create the project you are going to use.
10. Select Configuration mode.
a. Select the Hardware tab.
b. Double-click the GPS icon, or select GPS and click
c. In the Hardware Type box, select GPS (Placer DR, 400, SV6; TAIP)
if the Trimble Placer GPS 400 or SVeeSix has TAIP. See part number
XXXXX-63.
d. In the Hardware Type box, select GPS (SV6, SK8; TSIP) if the
Trimble Placer SVeeSix has TSIP. See part number XXXXX-61.
Agilent Wireless Solutions
.
Modify
55