NOTE
NOTE
Setting Up Your System
Receiver and Phone-Based System Setup
10. Configure the Trimble Placer GPS 455 unit for the correct settings. See
"Selecting GPS Hardware" on page 120
11. Configure the phone:
a. Select Configuration mode.
b. Select the Hardware tab.
c. Double-click the phone icon or select the phone icon and click
d. In the Hardware Type box, select the phone used.
e. Click the Port Selections and Port Settings tabs to modify and confirm
the correct COM port setting for the phone. The port selection should
be serial and select the COM port you are using.
f.
Use the default port settings or use the values according to the
PCMCIA Socket I/O card you are using.
g. Click
when you are satisfied with the settings.
OK
h. Select Collection mode to start the measurements.
Never set your GPS receiver protocol as TAIP and TSIP together. The
Agilent Wireless Solutions Software is designed to work with one protocol at
a time. Having both protocols active may confuse the system.
If you need to change the GPS coordinate datum, select the
GPS hardware configuration box. The default datum can be set using the
and selecting the Default Datum tab.
Tools > Options
60
for more information.
Advanced
Agilent Wireless Solutions
.
Modify
tab of