NOTE
Setting Up Your System
Receiver and Phone-Based System Setup
c. Double-click the GPS icon, or select GPS, then click
d. In the Hardware Type box, select the GPS (Placer DR, 400, SV6;
TAIP)
e. Click
when you are satisfied with the settings.
OK
If you need to change the GPS coordinate datum, select the
GPS hardware configuration box. The default datum can be set using the
and selecting the Default Datum tab.
Tools > Options
13. Configure the phone:
a. Select Configuration mode.
b. Select the Hardware tab.
c. Double-click the phone icon or select the phone icon and click
d. In the Hardware Type box, select the phone used.
e. Click the Port Selections and Port Settings tabs to modify and confirm
the correct COM port setting for the phone. The port selection should
be serial. Select the Com port you are using.
f.
Use the default port settings or use the values according to the
PCMCIA Socket I/O card you are using.
g. Click
when you are satisfied with the settings.
OK
h. Select Collection mode to start the measurements.
Accept the default settings for baud rate, parity, and others.
For additional information and vehicle connections for Trimble Placer units,
refer to Trimble Navigation Limited documentation.
52
.
Modify
tab of
Advanced
.
Modify
Agilent Wireless Solutions