NOTE
Setting Up Your System
Receiver and Phone-Based System Setup
e. In the Hardware Type box, select GPS (NMEA) if the Trimble Placer
SVeeSix has NMEA (National Marine Electronics Association: a
GPS protocol). See part number XXXXX-62.
f.
Click the Port Selections and Port Settings tabs to modify and confirm
the correct COM port setting for the GPS.
g. Click
when you are satisfied with the settings.
OK
If you need to change the GPS coordinate datum, select the
GPS hardware configuration box. The default datum can be set using the
and selecting the Default Datum tab.
Tools > Options
11. Configure the phone:
a. Select Configuration mode.
b. Select the Hardware tab.
c. Double-click the phone icon or select the phone icon and click the
button.
Modify
d. In the Hardware Type box, select the phone used.
e. Click the Port Selections and Port Settings tabs to modify and confirm
the correct COM port setting for the phone. The port selection should
be serial and select the Com port you are using.
f.
Use the default port settings or use the values according to the
PCMCIA Socket I/O card you are using.
g. Click
when you are satisfied with the settings.
OK
h. Select Collection mode to start the measurements.
Accept the default settings for baud rate, parity, and others.
For additional information and vehicle connections for Trimble Placer units,
refer to Trimble Navigation Limited documentation.
56
tab of
Advanced
Agilent Wireless Solutions