Agilent Technologies E7474A Getting Started Manual page 80

NOTE
Setting Up Your System
Phone-Based System Setup
9. Configure the phone:
a. Select Configuration mode.
b. Select the Hardware tab.
c. Double-click the phone icon or select the phone icon and click
d. In the Hardware Type box, select the phone used.
e. Click the Port Selections and Port Settings tabs to modify and confirm
the correct COM port setting for the phone. The port selection should
be serial and select the Com port you are using.
f. Use the default port settings or use the values according to the
PCMCIA Socket I/O card you are using.
when you are satisfied with the settings.
g. Click
OK
h. Select Collection mode to start the measurements.
Never set your GPS receiver protocol as TAIP and TSIP together. The
Agilent Wireless Solutions Software is designed to work with one protocol at
a time. Having both protocols active may confuse the system.
For additional information and vehicle connections for Trimble Placer units,
refer to Trimble Navigation Limited documentation.
90
.
Modify
Agilent Wireless Solutions