Agilent Technologies E7474A Getting Started Manual page 77

Setting Up Your System
Phone-Based System Setup
4. Press F1 to set the correct baud rate for the differential GPS. Use the
Table 2-4 Trimble Baud Rate Settings
Differential GPS
Placer GPS/DR
Trimble Placer GPS 455
Agilent E645x with internal
GPS (Trimble model SK-8)
When the differential GPS is correctly configured, it will start to send legible
information to the PC. If the subscription is active, this information will be
correction data, otherwise it will be scanned frequencies.
NOTE
If you need to change the GPS coordinate datum, select the Advanced tab of
GPS hardware configuration box. The default datum can be set using the
Tools > Options
Please contact DCI for information about getting a subscription to activate
your differential GPS. Once activated, it is ready to work with the
Agilent Technologies system.
Agilent Wireless Solutions
following table to set the baud rate for the Trimble model you are using.
Use F1 to set the baud rate of
the DCI model RDS 3000
differential GPS
9600
9600
4800
and selecting the default datum tab.
Then use F2 to set the baud
rate of the PC serial port
9600
9600
4800
87