Important Notices; Important Deployment Information; Service & Safety; Safety Warnings - Redline RAS-Extend M Installation Manuallines

RDL-3000 RAS-Extend M Installation Guidelines
1

Important Notices

1.1

Important Deployment Information

IMPORTANT: Refer to the RDL-3000 Family User Manual for detailed regulatory
information. Refer to this document before deploying and powering RDL-3000 family
systems in the field.
1.2 Service & Safety

Safety Warnings


WARNING - MOVING EQUIPMENT: When power is applied this unit may reposition
itself automatically without operator intervention.

WARNING - MICROWAVE TRANSMISSIONS: Do not operate or work in close
proximity to this equipment without first having proper training or knowledge of
microwave radio operation.

Read this manual and follow all operating and safety instructions.

Installation of the system must be contracted to a professional installer.

Keep all product information for future reference.

The power requirements are indicated on the product-marking label. Do not exceed
the described limits.

The unit must not be located near power lines or other electrical power circuits.

Disconnect the power before cleaning, or when the unit is not be in-use for an
extended period.

The system must be properly grounded to protect against power surges and
accumulated static electricity. The user is responsible for installing this device in
accordance with the local electrical codes: correct installation procedures for
grounding the unit, mast, lead-in wire and discharge unit, location of discharge unit,
size of grounding conductors and connection requirements for grounding electrodes.

General Warnings

Redline recommendations for maximum safety include the following:

Do not operate microwave equipment without first having proper training or
knowledge of microwave radio operation.

Do not operate the microwave equipment without an appropriate antenna port
termination, or antenna.

Do not look into or stand in front of an antenna.

Do not swing or aim an antenna at nearby persons while the equipment is operating.

Check to ensure that the area around the antenna is clear of personnel prior to
turning the transmitter on.

In locations where other antennas are installed, do not proceed with an installation
without first determining the RF/µW exposure risk. Where necessary have the
relevant transmitters turned off or wear a protective suit for the duration of the
installation.
70-00174-04-00 Proprietary Redline Communications © 2014
Chapter 1
Page 9 of 58 July 16, 2014