Table of Contents
Advertisement
RDL-3000 RAS-Extend M Installation Guidelines
#
Item
1
Wireless Terminal
2
Antenna Positioner
3
Data & AC-DC
Power Adapter
4
MIMO antenna
5
Wireless Terminal
Mounting Bracket
6
AC Power Plug
7
Antenna RF Jumpers
8
Ethernet Cable
9
Power, Control & RF
Cable
10
Power & Data Cable
11
GPS Antenna Kit
70-00174-04-00
Table 3: Features- RAS-Extend M System Components
Description
RAS-Extend M wireless terminal.
RAS-Extend M antenna positioner.
IMPORTANT: The installer must provide a fabricated mounting
plate properly affixed to the mast top and prepared with bolt holes
positioned as described in this document.
120/240 VAC to 48 VDC power adapter and Ethernet I/O port.
Directional antenna. Kit includes strain relief clips for RF cables.
Mounting hardware for wireless terminal. Fits 45 -115 mm (1.75 -
4.5 in) mast pipe. For use when the GPS arm is mounted
remotely.
Weatherproof AC plug. Must be attached to installer provided
power cord during installation.
Antenna RF jumper cables (positioner to antenna). Length is 610
mm (24 in).
Ethernet cable 91 m (300 ft) Ethernet cable pre-terminated with
shielded RJ-45 connectors both ends and mating weatherproof
connector for attachment to Power Supply unit (4).
Pre-terminated at both ends for connection between the Wireless
Terminal (1) and the Antenna Positioner (2).
Pre-terminated at both ends for connection between the Data +
Power Adapter (11-pin) and the Wireless Terminal (11-pin).
Length is 10 m (35 ft).
Kit includes 2x GPS antenna, 2x 1.2 m (4 ft) antenna cables
(TNC/F), 2x 6 m (20 ft) antenna cables (TNC/F), 2x antenna
bracket arm, and mounting hardware for 45 -115 mm (1.75 - 4.5
in) mast pipe. For mounting GPS antennas and wireless terminal.
Proprietary Redline Communications © 2014
Page
17
of 58
July 16, 2014
Advertisement
Table of Contents
