Redline’s liability under this warranty is limited to: (1) repair or replacement of any parts or product which are determined to be defective; or at Redline’s sole option (2) refund of the purchase price.
TURBO/HIGH PRESSURE FRONT VIEW 1. Power/Mode Selection Toggle Switch Toggle left for Turbo/High Pressure, Toggle right for Low Pressure EVAP 2. Turbo Testing Indicator Indicates Turbo / High Pressure testing selected 3. Flow Meter Measures flow rate into system under test 4.
Page 5
*NOTE: Fixed Pressure 11 - 14 in wc / 0.47 PSI / 0.032 BAR, adjustable regulator only affects high pressure testing BACK VIEW REAR / BACK VIEW 16. Fluid Fill Port Remove fluid fill plug to fill machine with Redline approved vapor producing agent 17. 12 V DC P ower able 18.
6. EVAP Service Tool Kit [96-0003] Schrader Valve Removal tool. Evap Service Port Adaptor. 7. Cap Plug Kit [ 96-0007 ] Seals a variety of openings in order to pressurize system for testing. 8. EVAP Quick Connect Hose for Speed Smoke [ 96-0656 ]...
Fill fluid to top of port d. Replace fluid fill plug 2 fl. oz. (60 ml) maximum. Only use Redline Approved Vapor Producing Fluid Never use dyes, solvents or other contaminants in intake or exhaust systems because they may coat and/or harm critical sensors, catalysts or filters 2.
The procedures in this section are intended to be basic guidelines for users to practice using the Speed Smoke Diagnostic Leak Locator (EVAP / Low Pressure mode) This operation manual is not intended to be used in place of common sense: •...
Page 9
EVAP/LOW PRESSURE TESTING FOR LEAKS VERIFY REPAIRS PERFORM DECAY / LEAK DOWN TEST Pressurize the sealed system Lock out sealed system by turning Flow Control Knob clockwise to the fully closed position OBSERVE PRESSURE GAUGE FOR DECAY: Pressure Holds: No leaks, Repair is complete Pressure Decreases: Leak(s) exist, Repair and retest until all repairs are complete NOTE: Not all systems are designed to be 100% sealed How To Diagnose Exhaust Leaks...
The procedures in this section are intended to be basic guidelines for users to practice using the Speed Smoke Diagnostic Leak Detector (TURBO / High Pressure mode). Speed Smoke Diagnostic Leak Detector is designed to be used in conjunction with the supplied Power Intake Adaptor, or threaded sensor port adaptors, also provided is a cooling system adaptor to test the ™...
Page 11
Cooling system leak testing can be performed two ways Use Speed Smoke to quickly and easily find cooling system leaks either with decay testing or using visible vapor. First, attach provided cooling system adaptor to pressurized coolant bottle or radiator at cap.
Adaptor. Bladder failures due to misuse or abuse are not covered by ™ warranty.Redline Detection shall not be responsible for any incidental or consequential damages. • Power Intake Adaptor must be mechanically anchored with the provided chain / cable to a secure ™...
• Ensure power cord is properly installed on a fully charged 12V DC Battery Red Light Flashing • Open circuit / internal component Contact Redline Detection Technical Support No Air Flow • Open the flow control valve • Check hoses are not kinked Poor Vapor Density or Volume •...