Table of Contents
Advertisement
RDL-3000 RAS-Extend M Installation Guidelines
2.2
RAS-Extend M Antenna Positioner
The RAS-Extend M antenna positioner unit controls the alignment of the antenna for the
RAS-Extend M system. Two pairs of RF ports conduct the RF signals between the static
base ports and the moving platform. Control signals and power are provided by the
RAS-Extend M wireless terminal.
Figure 6: Features: RAS-Extend M Antenna Positioner Ports
RF-1 In / RF-2 In
The two RF ports (N-Type / F) conduct RF signals between the antenna positioner and
the wireless terminal. A pre-terminated cable is provided to connect the antenna
positioner to the wireless terminal.
Position Control & Power In
The Position Control & Power In port (43-pin circular / M) delivers position control signals
and DC power to the RAS-Extend M antenna positioner A pre-terminated cable is
provided to connect the antenna positioner to the wireless terminal.
Important: The tethered cap must be cleaned and installed on this port immediately
whenever the Control + Power Cable is disconnected for any reason.
RF-1 Out / RF-2 Out
The two RF ports (N-Type/ F) conduct RF signals between the antenna positioner and
the MIMO antenna system. Pre-terminated cables are provided to connect the antenna
positioner to the MIMO antenna system.
70-00174-04-00
Proprietary Redline Communications © 2014
Page
20
of 58
July 16, 2014
Advertisement
Table of Contents
