SPECIFICATIONS SPECIFICATIONS Dimensions 12 in x 12 in x 9 in (31 cm x 31 cm x 23 cm) Weight - NanoLeak Finder Machine 19 lbs (8 kg) ™ Weight - Accessory Kit Only 4 lbs (2 kg) Shipping - Weight 25 lbs (12 kg) Shipping - Dimensions 19.5 in x 15 in x 23.5 in (50 cm x 38 cm x 60 cm)
14. Compressed Air Inlet Replace coupler fitting as necessary. Female 1/4 inch NPT fitting 15. NanoLeak Solution Fill Port Remove fluid fill plug to fill machine with Redline NanoLeak Solution 16. 12/24V DC Power Cable Inlet Port Depress to begin find leak procedure...
ACCESSORIES INCLUDED QUANTITY 1. Detachable 12/24V DC Power Cable [ 97-0164/B ] Detachable 12/24V DC power cable. 15 ft (5 m) 2. OEM-Approved NanoLeak Solution [ 96-0761 ] 8 fl. oz. (236 ml) Important: NanoLeak Solution contains NO Dye / Contaminants. *Replace solution every 1,000 tests or 4 months, whichever comes first 3.
Page 6
Air Brake NanoLeak Finder utilizes high test pressure that can damage components in evaporative emission ™ systems. Redline Detection manufactures low pressure OEM approved EVAP leak detectors such as Smoke Pro ® Total-Tech [PN 95-0003/B] and Smoke Pro Air Complete [ 95-0051 ] which are specifically designed for Fuel ®...
Attach output hose to installed adapter of system being tested with provided adapters NANOLEAK SOLUTION REPLACEMENT Replace Redline NanoLeak Solution every 1,000 Tests or 4 months, whichever comes first 1. Depressurize Machine a. Disconnect Compressed Air Line b. Connect DC Power c.
LEAKDOWN TEST TEST SYSTEM 1. Press “VEHICLE SELECT” to select desired vehicle configuration: • TRAILER NANOLEAK FINDER • TRACTOR VEHICLE: TRAILER TEST PRESSURE:115PSI • TRACTOR/TRAILER COMBINATION PRESSURE IN:118PSI • TRACTOR AND TWO TRAILER COMBINATION 2. Press “PRESSURE SELECT” to select desired test pressure: •...
FINDING LEAKS FIND LEAKS Perform FIND testing in a still air environment 1. With system completely depressurized including air holding tanks on vehicle, press FIND LEAKS FIND LEAKS MODE a. Find Leaks cycle initializes: 2 Minutes INITIALIZING... PLEASE STANDBY: 02:00 b.
Made in the USA NanoLeak Detection ™ Redline NanoLeak Signature Air consists of an environmentally friendly (non-polluting), contaminant free mixture. For this reason, the NanoLeak Signature Air can be released into the environment after the leak detection procedure is completed. The NanoLeak Handheld Leak Locator will detect even the most minute amounts of NanoLeak ™...
NANOLEAK HANDHELD LOCATOR OPERATION ™ LEAK SIZE INDICATOR The digital leak size indicator remains off normally but once a leak is detected, a number from 1-9 will be displayed for all NanoLeak Signature Air regardless of the sensitivity setting. The number will continue to increase or decrease depending on the amount of NanoLeak Signature Air that is detected.
NANOLEAK HANDHELD LOCATOR MAINTENANCE ™ BATTERIES: Install Batteries: Remove screw located at rear end of unit and pull down hinged battery door to open as shown. Always insert all four batteries into the battery compartment in the same direction. NOTE: polarity mark on the insided of the battery door for proper battery orientation SENSOR:...
Redline’s liability under this warranty is limited to: (1) repair or replacement of any parts or product which are determined to be defective; or at Redline’s sole option (2) refund of the purchase price.
Page 16
Technical Support +1 714-451-1411 Shop Online: www.RedlineDetection.com Manufactured in USA* By Redline Detection, LLC *w/ globally sourced components rev 12-04-2017 P/N 01-0126/B...