Table of Contents
Advertisement
2-6
9. Lift the light guard and place the spool of media on the supply
spindle with the number 1 side up.
Light Guard
ug
New Spool
of Media
Holes
10. Slowly rotate the spool until the two round holes on the spool
engage the lugs on the spindle.
11. Lower the light guard.
12. Thread the media around the guide roller, drive roller, and
idler roller, following the path indicated by the threading
arrows inside the media cassette.
13. Fold back approximately 1/2 inch (1 cm) at the end of the
media.
A-61038
July 1999
Advertisement
Table of Contents
