Lifting Machine - Komatsu PC15MRX-1 Operation And Maintenance Manual

OPERATION

LIFTING MACHINE

Never raise the machine with any worker on it.
Always make sure that the wire rope used for lifting the machine is of ample strength for the weight of
the machine.
Never try to lift the machine in any posture other than the posture given in the procedure below.
There is a hazard that the machine may lose its balance.
Never lift the machine with the upper structure swung to the side. Swing the work equipment so that it
is at the sprocket end and set the undercarriage and upper structure parallel before lifting.
When lifting, keep the machine horizontal.
It is dangerous to go under the machine when it is raised.
Never go under the machine in such cases.
Extend the variable blade and insert the pin securely.
NOTICE
The lifting procedure applies to machines with standard specifications.
The method of lifting differs according to the attachments and options actually installed. In such cases,
please contact your Komatsu distributor for information.
When lifting the machine, carry out the operation on flat ground as follows.
For details of the weight, see "SPECIFICATIONS (PAGE 5-2)".
When lifting the machine, carry out the operation on flat ground as follows.
1. Start the engine and swing the upper structure unit the
blade is in the rear of the machine body.
2. Raise the blade to the end.
3. Extend the bucket cylinder and arm cylinder fully, operate
the work equipment control lever so that the boom cylin-
der is perpendicular to the ground, then set the lock lever
to the LOCK position.
4. Set the boom swing pedal to the neutral position without
swinging the boom at all, then set the pedal lock to the
LOCK position.
5. Stop the engine and confirm that there is nothing around
the operator's seat, then get off the machine.
6. Extend the variable blade and insert the pin securely.
WARNING
TRANSPORTATION
3-69