Table of Contents
Advertisement
h
Insert the measured value as a Y Offset.
The value is positive if the transducer is physically located on the starboard
side of the origin.
or:
The value is negative if the transducer is physically located on the port side
of the origin.
i
Select
Save
j
At the bottom of the page, select
7
Close the
Installation
Related topics
Preparations, page 12
Calibrating the current velocity measurements, page 28
Functions and dialog boxes, page 35
Defining the file and folder settings for raw
data recording
Use the raw data recording functionality provided by the echo sounder system to save
echo data using the
*.raw
data storage device, according to the preferences you have defined.
Context
Before you start recording, make sure that you have defined where you wish to store
the data files. If you wish to save your recorded data on an external hard disk, make
sure that it is connected to the computer.
The
settings control how and where the recorded files are saved on the
File Setup
hard disk, or on an external storage device. By adding a prefix to the file names you
can identify the files you have recorded during a specific trip. You can also define a
maximum size of the files.
Note
The data files will normally become very large. If you wish to record large amounts
of data, make sure that you have enough space on your hard disk. The echo sounder
system is not provided with unlimited disk capacity. We recommend that you save the
data files to an external storage device.
Set up the recording parameters before you start the recording.
110-0002398/A
to keep the changes you have made.
dialog box.
format. The data are saved on the hard disk, or on an external
to save your settings.
Apply
Preparations
23
Advertisement
Table of Contents
