I/O Connectors; Attaching The Iox Board To The Processor Board - Intel NetStructure ZT 4901 Technical Specification

3.3
3.4
Intel® NetStructure
Downloaded from Elcodis.com electronic components distributor

I/O Connectors

The ZT 4901 provides the following connectors and features to interface with application-specific
devices:
•
The J10 board-to-board connector interfaces directly with a compatible connector on the
ZT 5524 Processor Board.
•
The J1 and J2 Compact PCI connectors interface with the backplane CompactPCI bus when
the board is inserted into a system master slot.
•
The J5 RPIO connector interfaces with the backplane's rear panel I/O connector.
•
Front-panel access is available for both PMC sites.
•
Front panel access is available for two, customer provided, Fibre Channel transceiver
modules.
Refer to Appendix A, "Specifications"

Attaching the IOX Board to the Processor Board

The IOX board must be attached to a host processor board before it can be installed in a system.
The following hardware is included with the ZT 4901 to attach it to the ZT 5524 Processor Board:
•
Roundhead Screws (5): Used to attach the standoffs to the ZT 4901.
•
Flathead Screws (5): Used to attach the ZT 5524 to the standoffs (and thereby the ZT 4901).
•
Standoffs (5): Used to secure the boards together and maintain 0.8 in board spacing.
•
Ejector Ganging Pins (2): Used to tie together the operation of the boards' ejectors.
TM
ZT 4901 Mezzanine Expansion Card Technical Product Specification
for connector descriptions and pinouts.
Getting Started
17