Table of Contents
Advertisement
B. Operational Keys Description
ode
M
NO.
Key
1
al
C
Mode
2
Clear
E nter
ode
M
Cal
al
C
3
Enter
E nter
4
Cal-
In conductivity measure mode, press this key to
go to the "Calibration" mode.
Mode/Clear-
Selects display mode. Pressing this key changes
the display sequentially to display Conductivity,
Salinity, TDS, Recall, Delete One and Delete All.
In the conductivity (salinity, TDS) mode, when the
"Mode/Clear" key is pressed for 5 seconds, the
meter clears all calibration values stored in the
internal memory.
In
the
Recall
"Mode/Clear" key to exit "Recall" and "Delete"
modes respectively.
Power/BLE (Bluetooth)-
Press and hold this key for 2 seconds to power on
and shut off the meter.
In the measure mode, press this key to turn
Bluetooth on or off.
Enter-
In the measure mode, press "Enter" key for 2
seconds to save reading into the data storage
site.
In the calibration mode, press "Enter" key to save
the current parameter to memory.
In the Recall mode, press "Enter" key to display
the last set of saved data.
In the "Delete All" mode, press "Enter" and enters
the selection screen.
In the "Delete One" mode, press "Enter" key to
delete a single set of data.
Figure 4
Description
and
Delete
5
modes,
press
Advertisement
Table of Contents
