Save, Recall And Delete Data; Preparing Conductivity Standard Solutions - JENCO 3177MB Operation Manual

C. Save, Recall And Delete Data
1. Saving readings to memory.
a. In the measure modes, press and hold "Enter" key for 2
seconds to save data. The "ID" icon and number with the
corresponding site number will lit up for a brief moment to
indicate a successful data save. Saving is now complete.
b. If "Full" lit up, this means that all 750 data saving sites are
used up. No new data can be saved until existing saved
data are deleted.
2. Recalling readings from memory.
a. Press "Mode/Clear" key until "dAtA rCL" shows. Press
"Enter" key to go into "Recall" mode.
b. To view data, press "Up" or "Down" key to select the
storage site number and displays the corresponding record.
c. Press "Mode/Clear" key to exit "Recall" mode.
3. Deleting data.
a. Press "Mode/Clear" key until the "dEL onE" or "dEL ALL"
shows. Then press the "Enter" key to go into the
corresponding "Delete one " or "Delete ALL" mode.
b. In the "Delete ALL" mode, press the "Enter" and enters the
selection screen. Use the "Up" or "Down" key to select
YES/no for clearing all stored data. To clear all data, select
YES and press the "Enter" key. "nonE" will show after data
is completely deleted.
c. In the "Delete one" mode, use "Up" or "Down" key to select
data to be deleted. Then press "Enter" key to delete.
Deletion is now complete. The next set of saved data will
automatically move up a slot in the storage site.
d. Press "Mode/Clear" key to exit "Delete" mode.
D. Preparing Conductivity Standard Solutions
Suitable conductivity standards are available commercially or
the user can prepare them using research grade reagents.
Here are some standard solutions the user can prepare to
calibrate the probe of the model 3177MB.
10