Table of Contents
Advertisement
INSTALLING THE BATTERIES
To insert the batteries into the meter, follow the procedure outlined
below.
1.
Use a Philip screw driver and unlock the battery cover by
turning the screw driver in the counter clockwise direction.
After unlocking the screw, take off the battery cover (Fig.1)
2.
Replace the old batteries with new ones and install them on
the correct polarity position.
3.
Put the battery cover back on the meter. Use a Philip screw
driver and turn the screw in the clockwise direction to lock the
battery cover.
CONNECTORS
1.
Conductivity/ATC connector (8 PIN connector)
2.
AC adaptor input connector
Figure 1: Battery compartment
Figure 2: Connectors
3
Advertisement
Table of Contents
