Showven SPARKULAR FALL User Manual page 9

C N . 00000001
6. Programming and Firing
a) Programming SPARKULAR
b) Heating up machine, it takes around 5min. it various according to the voltage and
environment temperature.
c) Make sure the prescribed safety zone is clear.
d) Suggest to clear material before firing.
e) Firing. In order to prevent overheat in the heating chamber and protect machine, the
maximum continuous firing time for SPARKULAR
f) The operator should always have a clear view of the device, so that he/she can stop the
show immediately when there is danger.
g) Clear material for SPARKULAR® FALL for 5s after show, clear material will remove the
remaining particles from heating chamber. For angled installation please elongate clear
material time.
7. Turn off and Clean up
a) Power off SPARKULAR
b) Disconnect all POWER and DMX cables. Remove the machine from truss carefully.
c) Empty the remaining HC8200 in hopper, and store the remaining HC8200 in a dry sealed
bottle for next time use. Never touch the output nozzle of SPARKULAR® FALL when empty
the hopper. DANGER OF GET BURNT!
d) Clean the surroundings to remove powder residues.
Wireless Control Information
Δ
1. Wireless remote control mode:
When use wireless remote control, please unplug DMX cable connection on machine, set
Wireless Control at ON status, match the remote controller with machine, pull out the antenna
on remote controller.
®
FALL, set the firing height, firing sequences etc.
®
FALL, allow SPARKULAR
®
FALL is 30s.
®
FALL to cool down.