Address And Main/Sub Setting - Daikin SkyAir RZR-P Series Service Manual

SiUS281117
2.3

Address and MAIN/SUB Setting

Introduction
To set the wireless remote controller, you have to set the address for:
 The receiver of the wireless remote controller
 The wireless remote controller.
Setting the Address for the Receiver
The address for the receiver of the wireless remote controller is factory setting to 1. To change
this setting, proceed as follows:
Set the wireless address switch (SS2) on the PCB according to the table below.
Wireless address
When using both a wired and a wireless remote controller for 1 indoor unit, the wired controller
should be set to MAIN. Therefore, set the MAIN/SUB switch (SS1) of the receiver to SUB.
MAIN/SUB switch
Setting the Address for the Wireless Remote Controller
The address for the wireless remote controller is factory setting to 1. To change this setting,
proceed as follows:
1. Hold down the "
2. Press the "
3. Press the "
4. Press the "
5. Hold down the "
24
Unit No. No. 1
switch (SS2)
MAIN/SUB MAIN
S
(SS1)
M
" button and the
/TEST
" " button for at least 4 seconds to
get the Field setting mode.
(Indicated in the display area in the figure at
right.)
FAN
" button and select a multiple
setting (A/b). Each time the button is pressed
the display switches between "A" and "b".
" button or "
UP
the address.
1 2 3 4 5
Address can be set from 1 to 6, but set it to 1 ~
3 and to same address as the receiver. (The
receiver does not work with address 4 ~ 6.)
RESERVE
" button to enter the setting.
/TEST
" button for at least 1 second to quit the Field setting mode and
return to the normal display.
No. 2 No. 3
SUB
S
M
Mode
Address
" button to set
DOWN
Multiple
setting
6
Wireless Remote Controller
Remote Controller
3
2
4
1
5