Daikin SkyAir RZR-P Series Service Manual page 27

SiUS281117
1.4.2 BRC1E71
In order to conduct the centralized remote control using the centralized remote controller and
the unified ON/OFF controller, Group No. settings should be made by group using the operating
remote controller.
Make Group No. settings for centralized remote control using the operating remote controller.
<Group Address (Unit)>
Basic screen
is displayed.
Press Press and hold
Cancel Cancel button
button for 4 seconds
once. or more.
Service
settings menu
is displayed.
Service settings menu
Group Address
 For setting group No. of Heat Reclaim Ventilator and wiring adaptor for other air
Note:
NOTICE
Enter the group No. and installation place of the indoor unit into the attached installation table.
Be sure to keep the installation table with the operation manual for maintenance.
20
Select "Group Address"
and then press Menu/OK
button.
Press Cancel
button once.
Press Cancel
button once.
Select the
desired Group
Address using
the /
(Up/Down)
buttons, and then
press Menu/OK
button.
Press Cancel
button once.
Item 2
Group Address (Group)
Group Address (Unit)
conditioners, etc., refer to the installation manual attached.
Item 2 is
displayed.
Select "Group
Address (Unit)"
and then press
Menu/OK button.
Item 2 is
displayed.
Select Group
Address using
the / buttons,
and then press
Menu/OK button.
Item 2 is
displayed.
 Description
This menu is used to make group address setting for centralized
control.
It is also used to make group address setting by indoor unit.
Wired Remote Controller
Remote Controller